Hi!
I'm trying to get the good configuration for multicast routing and IGMP.
See attached diagram.
I have a source in VLAN 25 and clients in VLAN 4, routing throught the C3750X L3 switch, with 2 C2960X switches as L2.
I'm not sure If I got it corr...
Hello!
I'm currently running under VTP version 3.
Somehow, I can't add another VLAN.
switch1(config)#vlan 41VTP VLAN configuration not allowed when device is not the primary server for vlan database.
Running:
Cisco IOS Software, C3750E Software...
Hi!
I was wondering if in the same stack of 2 swites, if you could have 2 switches with different module type:
Exemple: In switch unit 1 I would have a 4 port SFP 1gig module and in switch unit 2, a Tengig SFP 4 port module.
So, is this possible?...
Hello!
I'm trying to make the NTP synchronisation work by the management interface and vrf.
Here's my config that does not work:
It doesn't even seem to get started at all...
clock protocol ntp vdc 1ip access-list copp-system-acl-ntp 10 permit ...
Seems like this is the solution:
https://www.cisco.com/c/en/us/td/docs/switches/datacenter/sw/5_x/nx-os/system_management/configuration/guide/sm_nx_os_cg/sm_8scheduler.pdf
Page: 12-191