Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, we had a similar problem (https://supportforums.cisco.com/thread/2148408) before, and it was solved.But since a couple of weeks people are complaining about disconnections of the RDP sessions, even if they are working, so is not a timeout se...
Hello, I was wondring if there is a way to allow a specific desktop (mac) just in a specific port. Port Security did not work, if you change the desktop and not connect anything in the port with port security. Static Mac address neither worked.Sugges...
Hello, I have a question if I Stack a Catalyst 3750 L3 with a Catalyst just L2, will we able to use all L3 capabilities? Switches are WS-C3750G-24TS-E1UWS-C3750V2-24PS-SThanks
Hello. We have the next Settings in our SW. We crate an ACL and aplied to a SVI for Incomming Traffic, I understand that is not necesasry to allow the returning traffic in ACL, but we can't access to rdp for example when we add the ACL, if we remove ...
I need to see the mac address table in this switch and the command "show mac-address-table" does not exist.IOS Version 12.0(14)W5(20).Thanks in advance
Hello. I have these 2 commands runningssl server-version tlsv1-onlyssl client-version tlsv1-only But when I run this tool https://www.ssllabs.com the vulnerability still there...Cisco ASA 5520 9.0(1) Thanks
Sorry, is note the answer, I click on that by mistake.Nothing has change in ASA, I think is a issue on Windows 7 or later, with some specific update/patch, but I am not sure which one.Thanks
Thanks Again Jonathan, I had consider the options that you have suggested, but I should configure all switch ports in this way right? With all implicantions ragarding the administrative work.I want that Workstation with Mac A just work isuccesfuly in...
ThanksThe switches are not connected yet, they are in their box, it will be a new implemntation. And we just would like to know if is possible using L3 capabilities in a Stack with one Layer 3 Switch and the rest of them just L2.Regards
