Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Here is the network
otherRouter-SiteArouter -- {Provider Allstream Switched Ethernet) -- SiteBrouter
|
router(10.96.20.16, which has 10.1.44.1/24 interface)
Gi0/0 is Switched Ethernet interface f...
my ASA 5510 works fine, all tunnels I built are fine. The x.x.x.x is not in my peer and I don't know who it is. When I check from real-time log viewer, it doesn't show source/destination IP/port, it keeps generating every 2~3 seconds and fills my log...
Hi Guys,I have new ASA 5520 and configured all Internet traffic natting (PAT) to 10.97.20.1, and I have inside network 10.5.5.0 will go through mpls to another site - which I wanted to nat it as 10.97.5.0, but it always translate all inside address t...
Two ASA 5520 (ASA SSM-10) configured as active/standby failover, they can sync configuration no problem. The only issue is that one box will show Failed after a while -- whateve I configured it as primary or secondary, always the same box. I used deb...
Hi Rolf,
Report you back
I removed the HSRP facing providers, no static routes leaking out. So I removed those tricky recursive routes and all back to normal now. Thanks again!
Thanks Rolf,
it is amazing, just works! Let it work this way at this moment.
Yes, it is pretty ugly
I really don't know when I can get rid of /11, so I will try to persuade ASA customer to create a new interface/IP then I can build neighbourship co...
Thanks Rolf,
1) On SiteA router you have a static route pointing to 10.96.20.16 and you redistribute this route into OSPF. Is 10.96.20.16 also an OSPF neighbor? And if so, could you do the redistribution on that neighbor router instead?
10.96.20.16 i...
Thank you the lab, it is exactly my scenario!
Forget my static neighbor, it worked because I removed network 10.96/11 as your first solution.
However,I have several routers need to build relation to SiteArouter through 10.96/11, so it will be your 2n...
I will use static nei for all neighbourship now instead of /11 network statement, which is out of control and also made a lot of unnecessary link. /11 is easy for static route management, no need to worry about routing, which was setup before me.
The...
