Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have two identical switches. One takes the port channel command the other does not. I have tried assigning vlans to it but it doesnt matter. Same with shutting them down first. N5K9interface port-channel1switchport mode trunkspanning-tree port type...
Getting this error after logging in. If I try to download the software manually and install I get a different error "there is a problem with the windows installer package...."
This is a working example using static. But it doesn't work with the dynamic interface or I'm doing something wrong. Need to get rdp access to my laptop.-------------------------------------------------------------------------------------------------...
Trying to figure this all out. I'm getting untranslated hits. I posted the config I have so far.interface GigabitEthernet0/0 nameif outside security-level 0 ip address 10.1.1.1 255.255.255.0 !interface GigabitEthernet0/1 nameif inside security-level ...
@Rob Ingram wrote:From the CLI provide the output of "show nat detail" and "show access-list"> show nat detailManual NAT Policies (Section 1)1 (any) to (outside) source static Desktop interface service _|NatOrigSvc_c44e1f83-49d4-11ea-ad4b-51118e66ae...
OMG I did that ten times and now it took the command. Bless your talent! However [insert sad emoji]. I get this weird fabric path error. Everything else works except the 5k vpc peer link. N5K9(config-if)# sho run int e1/4interface Ethernet1/4switchp...
