Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I have a Nexus 6K - 2K fex setup. The FEXs are dual connected to the N6Ks. I have been tasked to SPAN all traffic on this set-up. The number of VLANs are more than 32, so I cant use VLANs as source. Also the total number of connected ports (incl ...
Hi, Is there a command similar to "reload in" for Nexus 5k and 3k.I have been searching, but couldnt find, hence thought of asking the expert community here.Thanks
Hi,We have a C4948E switch which is generating the following logs every ten minutes:May 28 12:44:13 UTC: %SEC_LOGIN-4-LOGIN_FAILED: Login failed [user: Username: -40.0] [Source: 0.0.0.0] [localport: 0] [Reason: Login Authentication Failed] at 12:44:1...
Hi,I have a set-up with multiple C2960 and C3750 switches. All these devices are being managed remotely. So basically I login to C2901, which is used as a Terminal Server, and reverse SSH to the console of each device.That's - I have assigned an IP ...
HI,I have two C2960 switches which have the management VLAN for other switches. These two switches are connected with each other via portchannel.Now the mgmt0 of few switches is connected to switch 1 and few other connect to switch 2.I have also conn...
Hi Mark, That post is referring to FEX port as SPAN destination - which I am aware - we cant use fex port as SPAN destination.I have 2K fex connecting to Nexus 6k on eth1/12. So all i want to know is can eth1/12 be configured as SPAN source.
Hi Mark,What I'm after is mirroring the 6k ports where the fex connect. That would save me from listing each connected port on fex as monitor source.I couldn't find that in the Cisco documentation, in source ports characteristics.
Hi Marvin,I have updated the IOS of the Cisco 2901 Terminal Server and since then the logs have stopped. It looks like there is some bug in the IOS, may be?
Sorry for coming back so late on this. The issue remains unresolved. What I have done is that I moved the HWIC Card to other port and can reach the devices. SO it looks more of a hardware issue than the config related.
HI Stuart,I can access other devices through the terminal server, just these two are problematic.the config is exactly same on other workign devices.. when i rebooted these devices via console (Terminal server), thats when the problem started.Regards...
