Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Introduction“Wireless clients are experiencing very slow speed” , is a common problem on a wireless lan environment.As part of troubleshooting this, we got to take care of1) Low Signal Strength.2) Low SNR.3) Insufficient Data rate...
Hi Mal,1) Log the SSH session to a text file.2) Execute "Config paging disable"3) Execute the commadsa) show run-configb) show msglogc) show traplog 4) Attach the text file to this thread. ThanksVictor
Hello Paul, 1) If the AP is UP on a WLC.. then it already has an IP address. Check "show ip int b".If the AP is not UP on a WLC, then assign an IP address to the BVI..(AP)# debug capwap console cli(Ap)#config t(Ap)(config)# int bvI 1(AP)(config-if)#...
Hi Isgabrillo, Mesh Back-haul HAS to be setup with Static Channel mapping.MAP connects to a RAP like how a wireless client connects to an AP.So, if you make a static assignment on a RAP, its Children will fall on the same channel. ThanksVictor
Hi Paul, All you need is ...a) Image ( k9w7 for autonomous OR k9w8 for lightweight. )b) A tftp server.c) The AP's serial Console access.d) IP reach-ability between AP and the TFTP server. Then, use the following command:(AP)# archive download-sw ...
If you get all the APs on power level 1, then we may run into the following problems.a) it will create huge coverage overlap.b) it will inturn trigger frequent/un-necessary client roaming.c) Adjacent Channel interference. So based on the outputs, we ...
