Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi folks, If I plug a 6-port SFP card into an ASA5555-X, how do the ports get allocated on the CLI ?Do the card ports carry on form the copper ports beginning Gi0/8, Gi0/9 ..... or do they start at Gi1/0, Gi1/1 .... ? Thanks.
Feature: IOS firewall - Authentication ProxyQuestion 1: Can Auth Proxy be configured on a Tunnel interface ?Question 2: Can an Auth Proxy ACL be configured such that a specific destination address or network will trigger the auth proxy rather than a ...
Thansk Aaron, so are 'switchport' commands possible on these ports ?e.g. !interface GigabitEthernet0/0 switchport access vlan 300 switchport mode access speed auto duplex full no shutdown!
Your answer 1 - What if the Tunnel is on my inside interface and I configure the auth-proxy command & ACL on the Tunnel originating end to intercept traffic from the inside to the outside, can't I make the auth-proxy command process before the tunnel...
