Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Forum, Would any one stored the API for TMS 14.1.1 referenced as version 10 in version history ? There is no way to find it on the Cisco Site. There is a jump from 13.2 to 14.2 and no logs for 14.1.1. Thanks if you can post it. I offer a coffee...
Hello Forum, I have a simple question about phonebook configuration in TMS14.3.0.When I push a phonebook from TMS to a SX20 (TC7.1.1) the PhoneBook server Configuration is provisionned withhttps://IP@_TMS//tms/public/external/phonebook/phonebookservi...
Hello Everybody, I am challenged at a customer's who is deploying IPv6 for video with VCS Control to do Interworking IPv6/IPv4. I need to validate the design to be sure that Interworking is done as expected by Network team at customer's. As I underst...
Hello everybody,I am asked to go to a customer to check a TX9000 camera setup because users claim the eye-to-eye contact is not as expected. I remember on CTS 3010 that there was definetly a offset when looking someone in the eyes you had the feeling...
Hello,I run a lab for a customer in wich I should test Smart Scheduler but I cannot get it launched. I cann access the tmsagent/portal. I can click th home button and the settings button. I can access findme configuration but smart scheduler would no...
Hello @jomin,
Did you get an answer? I have the exact same problem using macro device mode on a single screen device Cisco room 55. After the macro runs, the configuration of the codec is stuck in dual for monitors. Thanks
Cecile
Hello Richard,
I know it's been a long time for this post, but were you able to make it work ? I am in the same situation with a very large room and the customer expects a touch at each side.
Thanks,
Cecile
Hello Ali,
I am afraid that the eye-contact is only a concept in Telepresence solutions. Mecanically speaking, to look straight in the eyes any remote users would be y looking at the camera and not the person on the screen. I made several configurat...
Hello,
We did it to leverage the camera HD quality with a very famous client PC software. We used an Extron MediaPort 200 which converts an HDMI input from the codec, into USB to the computer. We had to figure out very specifically the configuration ...
Hello Wayne, Thanks for your reply. I read the release notes but hte big difference between 14.1.1 and 14.2 is TMS Scheduler replaced by Smart Scheduler. I wondered if there would be any further impact with TMSPE ? If not, it will be perfect. Cecile
