Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, We recently upgraded our Active and standby VSM pair form 5.1a to 2.1.1 in preparation to go fomr ESX 5.0 to ESX 5.1.We did the upgrade in two environments without issue. However out prod evvironment is causing issues. The upgrade went fine , ...
I have the same issue. I noticed that it is the same for the Fortigate FW Single and HA.
We are going to open a case with MS ..... Will update if we get anywhere.
Hi ,Thanks for the reply.A show redundancy status show active with standby and successfully synced. I can do a system switchover without any problems.All vems show up initially until the Active-Active messages show up. Then the 2.1.1 vems disappear. ...
