Hi All, I'm updating an existing script to look for a Syslog entry and based on a match, proceed or exit. I can't seem to get this working and am looking for some guidance. Script works without Actions 1.0 to 1.8 but with Actions 1.0 to 1.8 fails to ...

I'm looking to adjust a script we use to reset the Cellular modems if a Track instance does down. The adjustments are to check the status of a Track and based on the result, loop back to reset the modem again, or proceed and exit the script. I'm havi...

Hi, can some-one please assist with suggestions for an EEM script to monitor the Cellular RSSI which the results can be checked by the script for IP routes to be removed and added for traffic to be sent to the same end-point for an IPsec tunnel but t...

I am trying to configure a Cisco 1941 router for connectivity to the Telstra NextG service using the APN telstra.internet.This APN does not require or use Usernames and passwords.The 1941 enforces the use of Encapsulation PPP on the Cellular interfac...