Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 4503 with a SupII+TS w/12 POE ports. While connecting some AP's to this switch, only 10 of the 11 AP's are receiving power, with the 11th port showing power-deny status. Is there any way to get this last AP to power up (short of using a POE ...
I have a 6509 with a WS-X6748-GE-TX (48 port 10/100/1000mb Ethernet) module. I am trying to convert one of the ports from a switchport to a routed port.I have issued the following commands: (config-if)# no switchport (config-if)# ip address 1...
I have just updated a VLAN interface on my router. I have two 6500's with GLBP configured. The particular interface had a primary and secondary IP address. I shutdown the interface on one router and deleted the secondary address then assigned the ori...
I have a 4506 w/Sup II+ engine running (cat4500-IPBASEK9-M), Version 12.2(50)SG1. Users are complaining of network slowness/not responding/dropping connections. Looking at the switch everything seems fine, however I did notice something odd, that I h...
I have searched the web and seen other posts regarding this issue but haven't found a solution or explanation to this problem....Here is my situation:I have multiple switches and multiple VLAN's throughout my facility that I need to implement Port Se...
Thanks to those who responded.The port is working correctly now, and I wish I could say why, but I have no idea. I disconnected the cable to test it and the ports at both ends with my Fluke. Everything checked out fine, plugged it back up the way it ...
I have enabled portfast as recommended, checked for errors, and it still is not talking. I have tried pinging it from the gateway with no results. I haved checked my DNS and WINS servers for any entries and they show none. I am at a loss for what to ...
