Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Before I get too deep into this, I want to specify that this is not the profile (.xml) file that I am referring to, but the actual configuration found in the CLI or ASDM. I understand that the following are not replicated between an active and standb...
I am in the process of spinning up a new Internet circuit in my Data Center and what to flip my routes to go out a secondary internet connection at our colo. What I am attempting is to have 2 default routes in my routing table (one with a higher met...
I have 2 core routers, 2 data centers and each has an ISP.
R1 is a VSS pair of 6807s in our main data center and is advertising a static default route for our primary Internet connection. This route is advertised via EIGRP to the rest of the network...
I manually added the missing "anyconnect profiles" from the global webvpn setting on the Secondary-Active and it replicated the configuration to the Primary-Standby as it should. I also added the missing webvpn settings under the affected group poli...
I ran across this issue today and had the same question about where exactly to enter the commands. I opened a Cisco TAC case and was told the following.
The configuration should entered just like this:
ASA (config)# webvpn
ASA (config-webvpn)# a...
I know that IOS and NX-OS are 2 completely different animals. With IOS, I would be able to have 2 routers with different ADs advertising default routes and see both of those routes elsewhere on my network. For example, on an intermediate router I w...
I think I might have figured this out, but I am not sure if the commands will work on the 7k. Nothing changes for the EEM on R1. It will do what it needs to do in the case of losing or regaining the primary Internet. I do, however, need a defined ...
