Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We are looking at a device "Cisco asa 5512-x security plus license with 250 SSL VPN license" and want to know if it support 250 Anyconnect VPN client. And no extra license (Plus/Apex) necessary for around 50 Anyconnect clients? Thanks.
Licensed feat...
We have two VRFs on our N7K and there is some traffic needs to be routed between. What is the best way to do this? I am thinking to create a separate VDC as a router to do routing. Can anybody point out if there is a problem with that or suggest a be...
We recently have problems with some clent ftp to our ftp site when they were using ftp active mode. And the session was terminated by the FW, ASA 5580.%ASA-4-406002: FTP port command different address: 174.129.205.194(10.204.138.136) to ftp.ncbi on i...
Some our switch ports being reset for multiple times itself for no reason. It happened on 4948, 4506 and 6509 switches and hosts are all Dell PC with Windows 7. About 90% of similar PC are working fine without this type of problem.Anybody knows possi...
We recently have this problem happened twice (two days in raw at almost at the same time range). Basically, Nexus 7k block all Vlans from the port-channel to the other 7k, then it unblocked them from the port immidiately or after 2-4 seconds. It fla...
VRF with RT is a good idea to do this. I tested it with just two VRFs + BGP and worked. We can use "export map" to control which subnet to be exported from the VRF and import to the other one. But I still prefer using VDC, which is like adding a sepe...
Thanks, Gregory. Routing seems not working with the physically connecting two interfaces in each VRFs on Nexus 7000. That is why we brought up a seperate VDC for it. Does anyone have successful experience routing between two VRFs locally on N7K? Than...
Thanks for your concern. The second VRF is used for a small group of backup Storage devices. They are used for copying data from a separate Data Center and they request high bandwidth, low latency. Basically we created it for bypassing our FW. But t...
Yes, you are right. The packet I captured in front of FW looks like "PORT 192,168,1,9,19,137\r\n" and "Active IP address: 192.168.1.9 (192.168.1.9)".Very interestingly, same client accessing an identical FTP server (but it has been put outside of the...
Here it is the test result:lhc3-4506-93#sh cable-diagnostics tdr interface g4/39Interface Speed Local pair Cable length Remote channel StatusGi4/39 1Gbps 1-2 N/A Unknown Terminated 3-6 N/A ...
