In order to unstack the switches I did issue a "no switch 2 provision" but not a no switch 1 as this is switch 1. When I issue: Switch# Write erase it just asks me to confirm, and says it completes successfully. When I issue: Switch# reload it just asks me to confirm the reload. It does NOT ask me to say yes or no to the config being changed. I wonder if it would only do that with "erase star"? Let me try all of these suggestions and report back.
... View more
Hello everyone. I have a 3750G that used to be a Stack Master of a stack comprised of 2 identical switches. Since then, we have removed the stack from production, and I factory defaulted the stack MEMBER and that went fine. I just held the "Mode" button on the front until the lights all lit up and then issued the reload command and the switch came back with no configuration OTHER than the vlan database I issued the "del vlan.dat" command to no avail. I just manually removed all the vlans. The stack MASTER on the other hand will NOT go back to factory defaults, and will also NOT erase the vlan database. Everything I try will NOT work. I've tried the following 1) Hold mode button & issue a reload after the lights start flashing 2) issue "Write Erase" then issue "reload" 3) issue "Write Erase", then issue "Write", then issue "reload" 4) issue "erase start" then issue "reload" (just in case the "write erase" command is being depriciated or something weird) 5) issue "erase start" then issue "copy run start" then issue "reload" Is there a special way to reset a StackMaster back to factory defaults? Any input would help!
... View more