Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hello,I have I VPN IPSEC work fine and in night its down I didn't change any think and the other company too after one day of cheking i can't resolv this problem so I ask for your help its very urgent all my data center in Production now you find bel...
hello,please you have any idea how can I configure QoS in the router CISCO1841 for the port IPSEC(UDP 500 ,UDP 4500) and the port tcp 4433 thx for your help
Hi,a have a router CISCO 1841 and I configured a NAT inside from the router to the firewall like this :ip nat inside source static firewall_adresse public_adresse and its work fine and when a added it I do this command "wr" to save the configuration...
I did show policy-map int fa0/1 and I had this :############ when i did not use the VPN ###########################1841#show policy-map interface fastEthernet0/1 FastEthernet0/1 Service-policy output: qostest Class-map: test (match-all) 1108...
I did that :###############################################class-map match-all test match protocol ipsecpolicy-map qostest class test bandwidth 1536interface FastEthernet0/1 ip address X.X.X.X 255.255.255.252 ip nat outside ip virtual-reassembly dup...
hello,please you have any idea how can I configure QoS in the router CISCO1841 for the port IPSEC(UDP 500 ,UDP 4500) and the port tcp 4433 thx for your help
in my question I mean : when there are big trafic in the router the VPN dont work and when I type show run it doesn't show me the output but when I stop the source of this big trafic the vpn is UP and there is an output for the "sh run " but I thin...
