Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
we have configured RIP on our Nexus 9508 switches.running NXOS: version 7.0(3)I2(2a)
The RIP config is to support an IBM mainframe that uses RIP and connects to the 9508 via OSA cards and a single layer 3 interface.
The config includes the "default-...
I have a pair of ace 20 modules in HA mode running A2(3.6a)I have a vlan "10" shared by two contexts, the only layer 3 interfaces for the vlan are these two contexts. there is no firewall involved.If I ping a server that resides on vlan 10 from conte...
We are running LMS 3.1 with campus manger 5.1.3 on a solaris platform.When a user tracking minor or major acquisition is run on our catalyst 6509e switches with sup720 supervisor cards the cpu % utilisation spikes up to the high 90's.Is this normal o...
we have catalyst 4506 and 4507 switches serving both voice and data.we have noticed that when soft rebooting a nortel 2004 phone it was taking 10 mins to reset.a trace on the switchport serving the phone showed numerous dhcp discover frames being ge...
Thought i would post the resolution of this issue for other users experiencing a similar problem.To recap, the issue was that I was experiencing ping drops from servers within one context but not from another.The rate of drops was approx 0.1% and thi...
Joe, here is the output of the show mac-address count.The reason that this investigation began was because another 6509e running the same s/w version maxed out at 100% cpu utilisation, this as you can imagine caused a major loss of service.When we in...
Joe, here is the show stack output as requested. I took a snapshot of the cpu at the same time.I ran the command before the spike, during the spike and after the spike and received the same output each time.Was that to be expected?Cheers
The cpu spike lasts only a few seconds so it will be difficult to run the command at that precise time, but I will give it a try.The switches affected are all vital production devices, so could the switch be adversely affected by the action of runnin...
