About cliffgoniea

cliffgoniea · 05-10-2010

Hey all,I have been very unsuccessful in finding a solution to this issue and am begining to believe that it is not possible...well, at least as we would like to do it.Our situation: We have a 6509-E (SUP-720, VSPA) that is the hub to several 2960's ...

cliffgoniea · 01-20-2016

Here is what we have recently been able to achieve: We have two sets of VSS 6509s with WAN interconnectivity between them over a microwave radio. We have one SSC-600 and one IPSEC-3 module in each of the four (4) chassis. We are encrypting all traffi...

cliffgoniea · 04-22-2015

Kiran,So, what you want to do is set up a network address translation, or NAT. I am going to assume that that one public IP address is the same address that your router uses. This means you need to set up a one to many or port address translation (PA...

cliffgoniea · 04-22-2015

Lee,Yes, you sure can. It's not recommended or anywhere near a best practice, but you can uplink a server to the 10GB port after setting it up as a switchport.Cliff

cliffgoniea · 02-11-2011

For anyone also looking for this solution...Cisco's official stance on this subject is that it is not supported. If I figure a way to make it work, I hope to remember to come here and post the solution.

Member Since	‎03-13-2006 02:56 PM
Date Last Visited	‎08-17-2018 12:04 AM
Posts	6

User Statistics

User Activity

6509-E dot1Q to 2960 via 3800

Here is what we have recently

Kiran,So, what you want to do

Lee,Yes, you sure can. It's

Re: 6509-E dot1Q to 2960 via 3800