Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We want to reach all VPN Clients via the inside interface of the ASA with icmp from the inside LAN.We are using DAP with ACL's to reach targets on the inside LAN from the VPN Clients.Problem:We only can reach the VPN Clients from hosts which have be...
ASA5520 Cisco IPSEC VPN Client using DAP HelloI want to have access to all connected VPN Clients from the inside LAN. The access should only be available if it is initiated from the inside LAN.Example Application: mstscThe VPN Client should only be...
I'm wondering if it is possible for the ASA to do stateful inspection in transparent mode?As far as I know at the moment it only works as a packet filter?Thanks
Authentication failes with message:ACS MSCHAP password is invalid.Group auth works perfect.This problem only occurs when the local ACS User has an \ in the username Domain\user123The auth works perfect with the same password and the Username user123 ...
Hello all,I want to know if it's possible to use the ASA5505 in a way that only one interface is connected to the LAN. A VPN Site to Site shall be done by NAT-T.The interface IP should be set by DHCP from a router. The router shall route the traffic ...
Thank you! Sounds very good!We experienced problems with the stateful function in transparent mode.We got no reply if we have no incomming rule at the outside interface to allow the connnection, which was initiated at the inside interface.Can you ple...
We want to allow all incomming sessions at the outside interface when they are initiated from the inside.(Stateful Firewall)Is this possible in transparent mode?Application inspection isn't needed.
Thanks for the answer.I want to use the transparent Firewall stateful:( Answers to outgoing session are allowed incomming because the initiation was from inside) Application Inspection as far as I know works on a higher OSI Level.
