HI team , Thanks in advance.... Is there any show commands available for find which user execute which command in cisco switch.in the show logg I can see only which user logged in to the switch at what time but cant able to find what thy done afte...
Hi all,
IF my current vlans deleted because of the new switch with higher configuration revision number , can I get the old vlans by restarting switch before save the configuration ? or is the vlan.dat file auto save while receiving the new vlan in...
HI,
Have a simple doubt, Will cisco switch send gratuitous arp if HSRP not enabled ???? in which conditions a cisco switch\router\firewall send gratuitous ARP ???
Hi, "'ip device tracking probe delay 10 "" , will it means that , normally cisco device (switch or router or firewall) automatically generate the ARP and if this command given it delays for 10 sec ? or it will delay the the unknown flooding for 1...
Thanks Karthik , From where the switch gets arp probes , will it automatically generate ? , i know switch will send gratuitous arp if HSRP is enabled , if hasrp is disabled why the switch sends arp until and unless an unknown unicast ocure , please...
Hi matt,thanks for your replay...Is this will same for all the switch..Because i had an experiance in another model (3700) that there was only one port in vlan that was down state and so the SVI was also down.But after giving the auto state exclude...
HI mufurnival, Thanks for your replay...can we determine whether a link is flapping or not with the help of IPSLA ? ofcource we can find the link is up or down with the help of IPSLA and track command, But what about the flapping link ?