Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Ok, so I have two WLC5508 controllers running 7.0.230.0, which having the two of them probably is inconsequential because all the APs are added to only one controller. The problem I'm facing is that I have several LAP1552E's deployed throughout my fa...
I haven't gotten the sniffer installed yet, but I have a new piece to the puzzle. I have some 3502i and 3502e devices on a separate bridge group and switch infrastructure, and today I was doing some unrelated work which required me to enable Ethernet...
Going to check the switch infrastructure next, but also deploying one of my 3502i APs in SE-Connect mode to determine if I'm seeing some interference. Too bad I can't use my 1552E for that.
Forgot to mention that, SNR is between 21 at the lowest and 37 at the highest. The MAP bridging the switch has one hop between it and the RAP, with both SNR being 24 and 27 respectively.
