Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi community,
I have a switch stack Cisco 3850 run IOS-XE. On this stack, I have 3 interface Vlan: 8, 10 and 12. I have configured vlan access-map for filtering traffic into Interface Vlan 10 and VLan 12. And I have configured an ACL for Interface V...
I want to implement MPLS VPN hub and spoke topology for my enterprise network. I have read some docs about MPLS VPN. In some examples about MPLS VPN hub and spoke topology, need two connection between hub CE router and hub PE router. So, how to confi...
Hi expert. I'm configuring my NAC 4.7.2 with two Windows 2008 SP2 (64bit) domain controller . I'm using ADSSO for XP and Win 7 clients. I test LDAP lookup via Auth Test in NAC Manager is OK, but ADSSO service could not start. So how can I fix this pr...
Hi all,I want to config VPN Failover on ASA 5520. My ASA behind an Load balancer which has two public IP addresses. Please guide me with this scenario.Thanks & Best Regards!
I want to remote desktop to a host behind ASA Firewall through Internet. My ASA Firewall connect to an Draytek Vigor Load Balancer. Please guide me how to config ASA Firewall for this.Thanks & Best Regards
Hi Rick,
The subnet mask and gateway on two workstations are the same. Here is the some configuration that relate this vlan
interface Vlan8 ip address 172.16.8.254 255.255.255.0 ip access-group DVL8 out!ip access-list extended DVL8 permit ip 172.16.1...
Could I configure the hub and spoke MPLS VPN with onlyu one logical link between Hub-CE and Hub-PE router.And in the real world, how many logical links between Hub-CE router and Hub-PE router of MPLS Provider?
