Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a multi floor building and want to implement a single SSID across all floors. Each floor will have about 10 APs. The building's network has been designed to route from the access layer. Meaning there is a L3 boundary between the access layer a...
I had to change one L2L VPN tunnel to main mode from aggressive. Now my EZVPN tunnel won't connect because of the mode change. I did not globally enable main mode, just on a single tunnel. If you need configs or logs let me know. I will paste them in...
Ok, so I have the EZVPN configured and passing data from two different remotes. I have been unsuccessful at getting that traffic back out to the internet. I can't use split tunnel. All traffic destined for the internet must route through the EZVPN se...
L3 roaming is on the table, but we wanted to switch locally (HREP, flexconnect e.g.) Not sure how L3 roaming is going to help me overcome the multi default VLAN issue though.Thankszman
Correct me if I am wrong but I thought the AP natively communicated in the untagged VLAN? Also let me give a little more detail. Here is the VLAN structure in the building:1st floordata VLAN 710 (will be tagged)AP VLAN 810 (Default VLAN, untagged)2nd...
Ryan,In your example the Default VLAN is 70. How do I configure multiple Default VLANs? Each floor in my design will have a different Default VLAN.Thankszman
Yes, each floor is an L3 switch with an L3 etherchannel uplink to the core. My translation of your next question is do I have a diagram to share, I do not.Thankszman
