Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am not seeing any utilization for configured pvc. while running dspchstatsi am seeing the message at the bottom conn sampling is disabled; CR to continue
I am getting the below output while pinging remote IPdistribution-1#Protocol [ip]:Target IP address: 172.28.9.254Repeat count [5]: 1000Datagram size [100]:Timeout in seconds [2]:Extended commands [n]: ySource address or interface: vlan255Type of serv...
on 4507r-config.txtRemove port fast from trunk interface Gi5/15(According to your configuration its configigured on the trunk interface gi5/15)interface GigabitEthernet5/15no spanning-tree portfastenable ip routing in configuration mode.ip routingChe...
It seems that filesystem on flash is got curruptedIssue the following commands for recoveryrommon>format flash:rommon>IP_ADDRESS=xxx.xxx.xxx.xxxrommon>IP_SUBNET_MASK=xxx.xxx.xxx.xxxrommon>DEFAULT_GATEWAY=xxx.xxx.xxx.xxxrommon>TFTP_SERVER=xxx.xxx.xxx....
Lets say a machine is having a mac-address 0002.a563.670cthen do show mac-address-table | i 0002.a563.670ce.gSwitch#show mac-address-table | i 0002.a563.670c0002.a563.670c Dynamic 325 FastEthernet0/3orC3BS1#show mac-address-table addre...
Here the configuration for a switch which is connected to the network monitoring device.!Define the RSPAN VLAN Let's say vlan 100vlan 100remote-span! Monitor session 1 captures bidirectional traffic from source vlan's to RSPAN VLAN 100.! let's say w...
