Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,We have recently performed ISE upgrade from 2.3 to 2.4 and than after almost 10 days we performed the patch upgrade for ISE 2.4 to Patch 10. Our policy for authenticating phones is Dot1x with Certificate based authentication using Locally Signe...
I have 1552E AP running on Cisco WLC image 8.3.x. IOS of the APs are running on Version 15.3(3)JDA13.
We are planning to upgrade our WLC to 8.5 software.
It was noticed from the compatibility matrix for wireless that 1550 APs with 64MB are not suppor...
Hi,We have MR74 Access Points, which consists of 4 N-Type connectors 2 each for 2.4 GHz and 5 GHz. I am confused as to which slot should we install the antennae on; If need to install 2 Antennae on an AP, should we consider 2.4 slot or 5 Slot?What if...
HiI am having a very unusual behavior with my WLC, as it has been up and running for sometime now and every thing was working fine but from today I started getting complaints that people are not able to connect to SSID. There is only one SSID being b...
Hi,I am having a Wism on 6500 chassis with software code 7.2.103.0 Now......... I use to have 7.2.111.3 on the Wism before but for some reason I had to downgrade the code to an older version (some compatibility issues with the NCS)......Now before al...
Is this really the solution to the problem? I am having ISE 2.4 with 4 PSNs, 2 PSNs are having all ports up, but the other 2 PSNs are not having 8443 & 8445 ports up, when I execute the command "show Ports". I have tried re-sync and also reloaded the...
great info George, but do you know if the new IOS based WLC can work with a 5508 anchor controller..I have 2x5760 controllers with IOS ver 3.3.1 and a 5508 controller with 7.4.x.x, can 5508 serve as an anchor controller or do we have limitations, if ...
Cheers mal,helped me a lot.... I deleted the directories and re-initialized the installation process... and it went smooth.... my MSE is up and running now with the new code
