Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
cisco 2651xm routerfirmware c2600-ipbasek9-mz.124-17hi and sorry for such a simple question but is it possible with this router to allocate a LAN ip address to DMZ? I have firewall and port forwarding and access lists already in this router and I don...
I have a cisco aironet AIR-LAP1242AG-E-K9 acces point that runs v12.4. if its any use this is the firmware in flash:BOOT path-list: flash:/c1240-k9w7-mx.124-10b.JA3/c1240-k9w7-mx.124-10b.JA3I'm trying to get debug to show wireless clients connecting ...
cisco 2651XM routerIOS: c2600-adventerprisek9-mz.124-15.T8.bin16port switch NM-16ESW fittedI want to monitor all traffic on network port f1/14 and output it to a tftpsyslog but I'm I'm only having partial success.I did:#debug int f1/14which seemed to...
I've got two 2600 routers connected to each other using site-to-site vpn. Problem is the connection goes down after a while. When I first start the routers the connection is there, but I come back half an hour later and there's no tunnel, neither rou...
IOS = C2600-ADVENTERPRISEK9-M), Version 12.4(23)I have a 2651XM router configured as a vpn client, it connects to another 2651XM router which is config'd as the vpn server. The vpn server end works fine.I want the client connection to be fully auto, ...
thankyou very much for your input. I had an error on the second line:ipbase(config-if)#ip address 10.10.10.254 255.255.255.0% IP addresses may not be configured on L2 links.so it seems my only option is to configure the port itself to DMZ
yes it would be ok to change the ip address. or do you mean change the subnet?I would like to access the pbx from local users but it's not essential. I think just DMZ would be better.
