Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have a decent sized SONET ring utilizing 15310's. I am having an issue with accessing the CTC application on any of the devices via the web interface. I believe they all have CTC version 7 installed on them. I have not been able to get the applet ...
I hope someone can point me in the correct direction here.I have a client that needs 4 machines with static internal addresses. He is using a remote filtering service that filters by public IP. I have set the proper NAT and Global statements I believ...
Thanks Frederic,After about 5-10 minutes of patience finally paid off for me here. Turns out, it just takes some time to load the CTC console. What threw me off was the message in the IE window stating the CTC Launch had failed.I tried your suggestio...
Ok, so I was able to figure out my issue here. Sorry for the long delay. I spoke with the ISP again after trying these suggestions and then just plugging my laptop in after the router and used the new public IP I was trying to set and also testing th...
I may have a chance to visit the client tomorrow. I will put together the config for what you have suggested and report back.I did hear back from the ISP and they say the address I am using is routed back to me, so I was wrong about that unfortunatel...
I also forgot to mention one thing. If I set the ASA's outside interface vlan IP to the IP I am trying to nat the inside client to, I cannot pass traffic. I would again assume the issue is down the line from me from this observation.
