Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I wonder if there is a fix for this bug in any 8.2 releases?
Release notes do NOT state this as a fixed or open caveat in any of the 8.2 subreleases.
/Keld Visti
Hi.When doing the backup from the GUI I can se several informations missing when I browse through the textfile with an editor. One og things i miss is AP grouping which is vital in this situation. Does anyone now how I do a backup getting all informa...
I am configuring a setup using ASA5505 at remote sites using easyvpn against a VPN3000. Futher I have to use inbound http proxy authentication for accessing a web-server on a DMZ zone on the remote ASA5505. I can get the two things to work indiviuall...
Hi.Has anyone found a smart way to handle large number of SA's and peers on a PIX VPN installation?Example: To check if a SA has been created you have to issue a "show crypto ipsec sa". This will list all SA's on all peers, in my case about 250 SA's ...
Hi Bryan.Thank you for your answer.I am running 7.2.2 and I have NOT configured redirection for the authentication request. I have in the mean time found out that the real problem is that the http request actually is redirectet to https despite the f...
The router will not learn this route through the E0/0 interface because when the EIGRP routing information hits this interface it will be encapsulated in GRE (either with or without IPSec). The packets are first decapsulated when it hits the tunnel0...
hi 1dkellyYou can setup a router at each location and run Datalinkswitching (Dlsw) on these.Dlsw works between two IP endpoints and is giving you bridge facilities. I have several installations running SNA over IPSec tunnels via Dlsw. The only thing ...
Hi Gary.I am aware of this parameter on the "show crypto ipsec sa" statement, but it does not work!I don't know if you have tried it, but the only thing it does is inserting a lot of empty lines in the output.regards Keld
Hi Pat.One way to solve the managment problem is to add the remote PIX outside IP address in the VPN tunnel. When you have done that you vil be able to access this IP address via the tunnel, thus being able to ping / telnet the PIX.Keld
