Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HI ALL, I have three different VRF on Nexus 7k, and we want those should be extend to Cisco ASA 5585 IOS 8.4.5...We had used the trunk port on Nexus 7k to ASA connectivity... and Dynamic protocl OSPF is running , both are in same area of OSPFWe are m...
HI ALL,I have three different VRF on Nexus 7k, and we want those should be extend to Cisco ASA 5585 IOS 8.4.5...We had used the trunk port on Nexus 7k to ASA connectivity... and Dynamic protocl OSPF is running , both are in same a...
Hi ,We have two L2 switches and 2 ASA firewalls, We have to use firewalls in Active standby mode.We want to terminate our internet connections to L2 switchs, then to firewall.Can we do this or how we can configure this.
I think packet flow is changed in 8.3 IOS and above.We are using private NAT for ouside traffic.can any body explain me why we are using private IP for outside traffic
I think packet flow is changed in 8.3 IOS and above.We are using private NAT for ouside traffic.can any body explain me why we are using private IP for outside traffic
Hi Dave,Switching facility is available only in 5505 ASA Firewall and above thing can be possible by extending the connectivity to switch or change the firewall mode to transparent.Please rate every post.Thanks Saurabh Goel
Hi Peng,You are using Static NAt and applying it with Interface IP address which is incorrect. As other users are also using the interface IP address for outside communication. Try to use specific public IP address for static NAT instead of Inetraf...
Hi Marek,we had created three separate SVI in switch for each VRF and correspondingly three subinterface on ASA firewall.the route the traffic towards VLAN and subinterfaces.Above soluting is working with static routing and OSPF also.if you need any...
