Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
IntroductionTopology overviewCatch-All with forward option:Catch-All with non-transparent serverfarm:Catch-All with transparent serverfarm:Catch-All with out-of-service transparent serverfarm:References IntroductionIn one-arm mode, you configure the...
IntroductionTopology overviewVersionACE ConfigurationScenario IntroductionCisco ACE modules support virtualized architecture to increase datacenter scalability. You can create upto 250 virtualized contexts on an ACE module. Cisco ACE working as loadb...
Hi Joseph,Can you get sniffer traces from the server while the ACE is probing it? When you mentioned that you are telneting to the server, were you GETting /cgi-bin/ERMS-PREP-statusRepo.cgi to get the HTTP200 Ok message you provided?Best regards,Ahma...
Can you reset the WCCP session between the Ironport and the 6K, SPAN the interface where the Ironport is connected, re-establish the WCCP session and collect the captures in pcap format, then upload them?!Can you get the show ip wccp commands from th...
I usually configure the probe (including the URL I need to test) apply it to the server farm, then check the show probe detail, it will show you the "Last status code" then configure it under the probe. Otherwise, you will need to capture the traffic...
