Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I know that in some NX-OS versions we need to manually set some default system-qos policies in order to make FCoE to work on Nexus 5500UP:switch(config-sys-qos)# service-policy type qos input fcoe-default-in-policy
switch(config-sys-qos)# ser...
Hi Bilal
I am in the case M1 -> F2E migration. In order to maintain alive one peer-link member, we decided to leave one M1 module on both N7K as first step. So, in the middle of migration path we will have a mixed M1,F2e scenario. L3 interfaces wil...
Hi
We will replace redundant Sup1 running NX-OS 5.2(3) (eligible for cold-boot manual upgrade to 6.X) with redundant Sup2E running NX-OS 6.2(16) Will vPCs work with these different releases? Do I need to disconnect all cables but peer-link and p...
Hi, thank your for your answer.I actually already enabled the system qos manually since we run 5.0(2)N2 release.We will implement FCoE over 5500. What I'm worried about is the warning message I posted above on Nexus 7009s connected to my 5500s after ...
Hi Ahmad,Thank you very much, so I got where I was wrong. Now it accepts my statements.Once I'll be able to test the service I'll post my feedback here.Thank you againMax
