Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
On a brand new RV325 with latest FW installed (v1.1.1.19 ), I often (daily) see huge 20 digits numbers in Tx Bytes or Rx Bytes that are wrong. Often, the unit is only up for few minutes after a power cycle and the Tx Bytes or Rx Bytes reports huge 2...
Hi,We are evaluating the RV325 unit. It is running the latest firmware (1.1.1.19). The firewall is up but when a port scan is performed (as a sanity check) from the outside (WAN side), I noticed port 80 is open. Why is port 80 open? There is n...
Hi,We are evaluating the RV325 unit. It is running the latest firmware (v1.1.1.19). The unit seems to be operating ok but we keep seeing this message "kernel: wrong ip[0],not_list[0]" repeatedly logged in the System Log. What does this message me...
Hi,Is there a way to view the list of ports opened by applications/device using UPNP? In RV042, there's a "UPnP Forwarding Table List" that gets updated when an application or a device opened a port via UPNP. I can't seem to find the equivalent in ...
Hi cchamorr,Thanks for reproducing it. I've reproduced it again on my setup and still see port 80 open. As I believe your findings is correct, I unplugged the line from ISP from WAN port and repeated the port scan. To my surprise, it still reports...
Hi stpa67001,Thanks for finding this out. This was not mentioned in the manual, help or in latest FW release notes that this was added. Where this is placed in UI, at Port Address Translation instead of Port Forwarding menu, it is not easy to find...
Hi,Thanks for your recommendation. But even with the case created, it will take some time and it may or may not happen. In the meantime, is there a way to mitigate this? Is there another place in the management UI that I can find out?
Hi,The Small Business Support Service Contract states it provides software/firmware releases. So what's the difference between this and the firmware release that I can download now on this link without a service contract.Regards,Albert
Hi,Thanks for you reply. Instead of looking my entire configuration, I suggest you to reproduce this issue on your RV325 unit:1. Apply the latest FW (v1.1.1.19) on your RV325.2. Reset to factory default. 3. Power cycle the unit.4. Double check a...
