Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Have anyone tested getting GLC-GE-100FX working on NM-4G in a Cat 9200? Have tried with ver 16.12.4 and 17.3.4b. In both cases show inventory looks a bit strange: No PID is read from the SFPswitch#show inventoryNAME: "c92xx Stack", DESCR: "c92xx Stac...
Migrating from CSPC 2.8.1 to 2.10.0.1 so have followed the migration guide and restored the backup.All looks OK except that I can't install and apply patch 2.10.0.1Nothing happens if I try clicking "upgrade now" from the GUI. So no prompt to accept E...
We have a FTD HA setup with 2 FP 2110 running FTD 6.4.0.10We see frequent messages like this in the ASAconsole.log in the standby unit%FTD-3-210005: LU allocate connection failed for UDP connection from INSIDE:X.X.X.X/64181 to OUTSIDE:8.8.8.8/53Outpu...
Is there ANY WAY to change the VTP mode and domain in a Catalyst 9500 from transparent to server without human intervention? That is without manually configure 'vtp mode server' and 'vtp domain MyVtpDomain'At one site they plugged in a Cisco switch w...
We have started to install ME2600X as access switch for FTTHTrunk ports are configured with rep and service instancesThese interfaces are facing Cat 4500X switches with rep edge ports. Northbound is a 6880X VSS and this is connected to the legacy net...
Well in my case, rebooting switches is unacceptable. Can't have 20-ish devices down for 5-6 min during reboot so a TAC case will be opened and we will just have try to reproduce the issue at the customer. If link flaps can cause the issue we hopefull...
Just out of interest. Has anyone opened a TAC case for this issue? I'm having problem at one customer on both C9200L and C9200CX switches running 17.12.4. The symptoms are clear and the only port on a switch left, after reboots have 27 linkdown event...
