You can run the command
show environment power
This will tell you how much power available to use
Mod Model Power Power Power Power Status Requested Requested Allocated Allocated (Watts) (Amp) (Watts) (Amp)--- ------------------- ------- --...
Yes that looks correct
Your zone configuration will look like this
zone name FS2_ESX09 vsan 100 fcalias name FS2-N0S1P1 fcalias name FS2-N1S1P1 fcalias name FS2-N2S1P1 fcalias name FS2-N3S1P1
fcalias name WAYESX09
zoneset name <name o...
Update zones/zoneset is a non-disruptive process. But, if you use WWN it may disrupt. The requirement for zones/zoneset is to use WWPN. You can find WWPN from "show flogi database" command.
So Please use WWPNs instead.
1. Created the n...
Hello Abdel,The below are SFPs you can use for SSN-16 line card DS-SFP-FCGE-SWCisco MDS 9000 Family Gigabit Ethernet, 1/2-Gbps Fibre Channel-Shortwave, SFP, LCDS-SFP-FCGE-LWCisco MDS 9000 Family Gigabit Ethernet, 1/2-Gbps Fibre Channel-Longwave, SFP,...
Lun zoning is not support on MDS 9148 (Sabre ASIC hardware does not support lun zoning functionality)https://tools.cisco.com/bugsearch/bug/CSCuj56321DescriptionSymptom:Correct documentation to note that LUN Zoning and read-only zones were removed at ...