Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
Try these commands:show device-alias database | i 20:00:00:25:b5:2d:b0:09|ESXUCSD9|ESXUCSD10|20:00:00:25:b5:2d:b0:0a|Totalshow zone internal ddas-table | i 20:00:00:25:b5:2d:b0:09|ESXUCSD9|ESXUCSD10|20:00:00:25:b5:2d:b0:0a|Total
Might be this b...
Hi,
Might be hitting one of these bugs.
CSCuu59941 FC ports errDisabled - SFP vendor not supported after upgrade to 6.x/7.x – fixed in 7.3(0)N1(1) 7.2(1)N1(1) 7.2(0)N1(1) 7.1(2)N1(1) 7.0(7)N1(1) CSCuv44148 Ports status "down (SFP not inserted)...
Hi,Cisco interop mode is not needed if the Brocade switch is in AG mode.Just enable feature npiv, which is non-disruptive, on the Cisco switch. You may want to refer to this post.connecting-brocade-in-access-gateway-mode-to-mdsRegards,David
Hi,"Show zoneset" only shows the full zoning database.The running configuration contains both the full zone database and a copy of the active zoning database.Regards,David
Hi,
Right click on the Brocade switch and select purge.
It removes it from DCNM and is non-disruptive.
Purge Down Elements
http://www.cisco.com/c/en/us/td/docs/switches/datacenter/sw/10_2_x/fundamentals/DCNM_Fundamentals_10_2_x/fmc.html#pgfId-344971
