Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,Supose I have "9513", connected to it several "Bladecenters" and several "9513" switches.My wish is to discover the attached switches with CLI commands.The additional 9513 I can recognize with "show topology" that gives me the attached (trunk,...
Hi all,I've a pickle - MDS IBM FC Bladecenter does not have the next CLI commands:show zoneshow zoneset show topologyshow fcs databaseshow fcns database show flogi databaseThe ouput for running those commands: Syntax error while parsing 'show flo...
Hi all,I would like to know the meaning and consequences of the next port's states:SFP not presentLink failure: loss of signalLink failure or not-connectedExternally Disabled Best regards,Igor.
Hi all,I would like to know the best way to configure the next properties (bolded and underlined):show zone status: VSAN: 1 default-zone: deny distribute: active only Interop: default mode...
Hi all,I came across a couple of issues I cannot figure out:I have in my environment some switches that do not have the ablity to run "SHOW FLOGI DATABASE". The switches are from the 91XX family. However, I can see the attached WWNs (on every port) i...
Another question:The output of "show fcs database" at MDS 9513 I get: FCS Local Database in VSAN: 1 ------------------------------ Switch WWN : XX:XX:XX:XX:XX:XX:XX:XX Switch Domain Id : 0x05(5) Switch Mgmt-A...
Thanks guys,So, "show npv flogi-table" gives me the flogi.What command will give me the connection to other switches? "show topology" gives me nothing, and I cannot detect that this switch is present from my other switch (MDS 9513). Ideas?Regards,Igo...
Thanks.So to make it clear, dedicated is mandatory for ports in port-channels, otherwise it's optional?There aren't issues of "overusing" dedicated?Best regards,Igor.
