Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Experts, I have a bit of a challenge that I would need your input on. First off I was just helping out a friend with this configuration and then he put more that I can chew write in my mouth. So I would need help to see how best i can get this ...
Hi Experts!Having a funny issue I'm experience, just thinking to myself what I could be doing wrong. I have 2 ASA's with software code 8.4.5 running on both of them, ASA1 is a 5510 that I have two active vpn connections on it a l2l with another ASA 5...
OK i know the first part of the situation is solved and I'm grateful to Jouni who elaborated me on it. But I have yet another pending situation that I could use a help here and really wouldn't mind been told this is where i got it all wrong.So finall...
Hi Experts,I believe this everyone is doing OK and getting along with your are doing? I have this funny scenario that happened on ASA 8.4 I configured recently for DMZ static nat. See the topology attached. I did configure the inside with a PAT objec...
Hi Experts,I keep getting such outcome on my sys log on the ASA, As much as I hate to say this, these are Chinese IPs, They've been flooding my network ever since today!%ASA-4-106023: Deny udp src outside:42.96.255.142/53 dst inside:192.168.200.196/6...
Hi Guys,
I recently experienced the same issue and tried a couple of things suggested here still had issues launching the KVM on my UCSE blade, my colleague showed me what worked for me without going about this the hard way. I thought it might help...
Hi Abolton, Are you saying that the access-list you configured would disappear as soon as the VPN tunnle goes down and you try renegotiating the tunnel again? That's strange!Is it possible you get your config pasted in here? that might help in troubl...
Hi Tony, Not necessarily! It should work if you get all your configurations correctly. But I would advice that you do so! Reasons being that when troubleshooting you have the same software code running on both firewalls. It's easier to focus on one s...
Hi Abolton, Ok just a quick question, have you tried adding your 172.16.32.0/23 into your access list above?Extended IP access list MyEZVPN_enterprise-list 10 permit ip 10.255.255.240 0.0.0.15 any 10 permit ip 176.16.32.0 0.0.1.255 any
Hi Madis,I have no experience with L2TP VPN on cisco ASA but I see something that I want to point out that might help out though. nat (any,any) source static VPN-network VPN-network destination static MyNet MyNet the any any interface statement might...
