Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Everyone,I searched on Google for this unique behavior I discovered on a pair of SG300-28P.On a second switch (ver 1.2.7.76) when I unplugged the power cord, to my amazement the switch turned right back on (about 1 second later), with the power co...
Hi Everyone,I have been learning a lot about Cisco switches and I had one setup with a few vlans (10,20,70). Recently I enabled inter-vlan routing on the switch and everything seemed to be going ok, and then suddenly file transfer rates between compu...
Hi Dimitri,We never did find a solution to this problem on the Cisco small business switches. Eventually we upgraded them all to the Cisco Catalyst 3750x and 3560x switches and these problems are not existant on the new switches. It may be some kind ...
Hi Thomas, Thank you for your response, here is a small diagram of the connection between the two switches.[GBE 3-1– SG-300-28P] | - From Ports 1, 4, 5, 7, 8, 11, 16 | | - (Trunk) | - To Ports 1-4, 16-18[GBE 4-1– SG-300-28P]The s...
Hi Dan and Glen,Thank you so much for replying to me. I did change the routing mtu back to default, however with it only switching I still found it going much slower than wire speed.It later was discovered that a downstream switch (esw-540-24p) does...
