Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
IntroductionGeneral QuestionsRelated Information Introduction With Ron Weaver During the live event Cisco expert Ron Weaver covered basic PNC operation, focusing on decoder management and service creation using a lab system. He also went through the ...
Cisco expert Ron Weaver covered basic PNC operation, focusing on decoder management and service creation using a lab system. Agenda PNCHow to access using the GUIHow to create a program or virtual channelAdding servicesAdding tiers to the programHow...
You can send a email to ssnrequest@cisco.com for this request. make sure to include the TID number of the receiver in the request. If the receiver is assigned to broadcaster it will require that Broadcasters approval as well as the approval of the B...
When doing a service replacement event the channel that you want the decoder to tune to has to be defined as an "Alternate". This is done under "Channels" then "Service Summary" If you open the service Assignment page for the channel you want to defi...
Service replacement allows you to black out a service for decoder and have the decoder output and alternate service. The program number will stay the same but the content will will change to the alternate program. This is mostly used for sporting ev...
Lisawhen you do a force tune of a decode either from its profile or by doing a global edit, a message goes out in the ADP (Address Data Packet) that tells the IRD to tune to the channel that you select in the profile. Because the ADP is targetet to ...
When doing audio pass through the audio is being externally encoded. The external device is where the delay is being introduced. There is a field in the D9036 under the audio setting in the Basics tab. Go to the bottom of the page and you will see th...
