Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have a problem with an IPv6 tunnel (ipv6ip) on a Cisco 1841 runnining 15.1(4)M4 or 15.1(4)M5.It appears that a bug was introduced into 15.1(4)M4 and it is related to IPv6 tunnels and IP SLA.interface Tunnel64 description IPv6 Tunnel to x.x.x.x i...
Many hours later I think I have worked it out - posting here so hopefully no one else spends as much time as I did trying to get this to work. In IOS-XE you have the option to enable "netconf ssh" or "netconf-yang" - I made the mistake of enabling "n...
Did you have any luck? I am suffering from the same issue in that I can't send CLI based configuration to an ISR running IOS-XE 16.9.6 (with "netconf-yang" enabled) - I keep on getting "<bad-element>config-text</bad-element>" when trying to use the "...
Hi Xander, Apologies if this has already been asked as I have been through most of the comments but couldn't find it. On an ASR 9010 (IOS-XR 5.3.4), I am trying to determine if it is possible to mark sub-interface traffic (using layer 3 and 4 headers...
Thanks Xander. I must admit after having spent the last few days trying to work this out, that the CLI does help in some instances, but it is inconsistent.
The following example shows the actual MIBs involved:
RP/0/RSP0/CPU0:Router(config)#snmp-ser...
Hi Xander,
In IOS-XR 5.3.x on the ASR9K, is it possible to obtain a list of all the possible traps that could get generated by enabling the various traps under "snmp-server traps x"?
I know I can obtain all the MIBs which are supported in IOS-XR an...
