Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,We are running Cisco Security Manager 4.4 service pack 1 and our ASA's are all running 9.0.2/9.1.1I've hit a problem with export to netflow from my ASA firewalls configured through CSM.We configure the netflow export under platform/logging and ena...
After upgrading the MDF (Common Services) and the device packages on our Cisco Prime LMS 4.1 installation we now get an error after logging in. The error is as follows; Status Not Found The requested resource was not found.https://X.X.X.X/cwportal/gr...
For OfficeExtend using DTLS we saw low speeds (<10mbps) on the OEAP600 Access Points. A Cisco engineer later confirmed that this was due to the fact that the AP did all the encryption in software and was underpowered CPU wise (couldn't handle more)
W...
I have only used packetfence in out-of-band mode (webauth) so I don't have any experience with using it inline in routed mode. I suggest you try the packetfence mailing list or try to figure it out using the available documentation from packetfence.
As I'm very busy with my normal job I'm unable to do support on this. I will ofcourse try to answer what I can here on the forum so please post any questions you might have here.
The documentation provided by packetfence is quite good both with regar...
Good luck! One last thing, if you use a production DHCP for IP assignment you'll need to forward these to the packetfence server.
I've done this by adding the packetfence server to the ip helpers setup on my guest vlan on the switch. This sends a cop...
