Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am currently trying to build a VPN tunnel from our network (using an ASA5505) to a
customer network using a Cisco 887VA-SEC-K9. The tunnel is working fine and traffic
can be exchanged. The only problem I have is creating the correct NAT statement
i...
I am trying to get the interface vlan command working on a IR809G-LTE-GA-K9 unit.
I am using the commands:
ena
conf t
interface vlan1
The 'interface vlan1' command fails with a statement indicating the command doesn't exist.
Does someone know why ...
Hi Friends,We are currently using a Cisco 887VA-K8-SEC to connect to a Cisco ASA 55XX.This is based on hostname resolving to for example: myvpnentry.mydomain.nlIt all works fine. But i want to add dnssec verification on the Cisco 887VA tomake sure th...
Hi gpauwen,
I didn't had the time to work on this project until today. I really can't get the client to update all his routers. I tried a different approach using nvi for dynamicly natting outside to inside traffic. It is working now, but this confi...
Hi gpauwen,
No the router is not under my control. There are in fact many more routers
present in this network. Only 10.6.24.1 is allowed upwards on the customer
network. That's exactly the reason why i am trying to nat the traffic going to the cust...
Hi gpauwen,
Thank you for helping out. I tried your permit rule but it did not work. I am using the extended NAT as a nonat list only for the dialer0 in order to nat traffic from inside to internet; in case our service engineer needs internet access ...
I still don't know if the vlan configuration option should be available.
In the mean time i devised a workaround.
I created a bridge IRB
and placed the two gigabit ethernet ports in bridge-group 1.
I also created a loopback device because i found ou...
