I can confirm in my setup too. I have two SB300-20s and a SB300-10 and a single SB200-08.The SB200-0...

I have not seen this issue after disabling bonjour discovery more than half a year ago. Since it cou...

After adding another trunk interface on my gateway router this switch started to misbehave again, on...

I ran the system using only the IP, and then back to using the FQDN again, and I have had no issues ...

I have now changed it back to use only the IP just to check.

It could be an compatibility issue with the server, but I have used this setup in many scenarios wit...

After having tried anything, including firmware upgrade, pulling the power, reboot and so on without...

I see the same behaviour on my SG200-08 switch. After several weeks the CPU stays at full utilizatio...

I forgot one crucial bit of information. Based on the findings in the trace I deactivated SNTP updat...

HelloI have a strange problem with a SG300-20 switch. I use check_mk (together with icinga) to monit...