Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear All, has any one tried to install firesight vmware file with (.ovf) extension not (.vmdk) extension and worked properly?!!because i installed (.ovf) file but i cannot perform any network discovery or monitoring users even if Firesight license is...
I have ASA (ver 8.4) with 2 ISP connections.Can i use Policy based NAT to have specific traffic use one ISP connection over another. say I have a User VLAN 10.10.10.0/24 and a Server VLAN 10.10.100.0/24.I want Users to use ISP1 and Servers to use IS...
Hi everyone, I am facing a problem with a cisco 6509 SUP720-3B that goes into rommon every time i restart. i tried these commands:rommon 1 > IP_ADDRESS=<ip address of router interface>rommon 2> IP_SUBNET_MASK=<subnet mask for the above IP>rommon 3...
Dear All, I have switch 4500 and when i loggin to the switch with console and trying to enter "enable" mode, i found this strange mode as shown in the attached picture.does any know the reason of that and how i enter the normal "enable" mode ?
thank you marvin for your reply, it is alright i solved the problem.
the cause of the problem is that there was no time syncronization between FireSIGHT Management Center and sfr module so the DC cannot view any events.
Hello,I recently acquired a WS-SUP720-3BXL Supervisor for a Cisco 6509 chassis, but have huge problems getting out of rommon mode.When the Supervisor boots it loads IOS, but makes a "Software forced reload" due to unknown chassis error - then it goes...
the problem here is the boot file is deleted from bootflash and the switch can not detect the flash(slot0: or disk0:) so i ask if there another way or workaround to copy the boot file directly to the bootflash or to make the switch boot from the comp...
