Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Our wireless environment consitst of 5 AP541N's configured with 2 VAP's. 1 VAP is for our private network and the second for unsecured guest access. I am wondering what the preferred wireless mode is to maximize network speed? We only have N devic...
We are trying to setup a WAP4410N with 2 SSID's. One SSID for our private network and the other for guest internet access. On the VLAN and QoS page there is a setting for priority. What would be the suggested values for this setting? We obviously...
Our wireless clients that connect through our AP541N cannot see other computers on the network. They can ping other computers by IP and host name and access the internet OK. Mapped network drives can be connected initially but are very unreliable a...
I have 2 AP541N units clustered. When I view Wireless Neighborhood I see our speed listed at 32MBPS on 1 unit and 34MBPS on the other. Do I have a setting wrong somewhere? What's the best way to increase our speed?
We have 3 AP541N units deployed in a doctors office. All of them are set to 802.11b/g/n mode. 2 of these units are used to provide non-secured internet access to patients and are using channel 7. The other AP is for our private network secured usi...
Any other settings on the AP541N that could effect network discovery?Side note: We do have 2 other AP541N devices serving as our public hotspot in the area. Station isolation is enabled on this public network. Could this impact our private network...
Does that mean my selectable channels will range from 6-11 only? I would prefer to have 1-11 as options. Will I have to change my Channel Bandwidth to 20mhz to accomplish this? Thanks.
