Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, we have set up ESA for a new customer and they reported that no email from a particular domain came through.
Looking at the message tracking logs gave no evidence that the sending domain attempted to send any mail but when we looked at the TLS ...
Hi, i'm deploying a new firepower instance on a 5525-X. I have removed the cx module, rebooted the firewall and installed the boot img successfully.
The ASA is running 9.4 (recommended)
However when i run the install i get the following error
system...
Hi, i've upgraded my FMC 6.0.0 to 6.0.1 and the upgrade has completed. However this message still persists in the Tasks window
The message persists after a reboot.
Anyone seen this before? or know how to get rid of it?
Best regards
Christian
Hi, we are tasked with setting up a PoC for a customer with ISE, 802.1x and posture.
the customer are planning on replacing their Symantec NAC solution and have some special requirements regarding a total functionality.
First and foremost they req...
Hi, I have set up a servicepolicy to redirect all traffic for a subnet to the Firepower module on my ASA. However there are certain ip addresses on that IP network that i would like to ommit from redirection to the Firepower module. I have tried to c...
Thanks for your efforts. However, here we discovered that there was hardcoded requirements set at the sending side that was the casue of the failiure. We had to contact the sender to update their configuration for our domain name.
Thanks for everyones contribution.
the fact is that the ftp server used have been used several times for this exact purpose and i could see in the logs that the data was transferring so connectivity was good, no drops in pings or anything. The Firepo...
Hi, and thanks for your reply.
Yes the connectivity is correct. I have used the same ftp server for a lot of installations.
I forgot to mention that the error message comes a long time after the download has started. Since there are no progress ba...
This is a great idea, thanks for the tip. I was just trying to figure out how to solve this when guest cwa is required to run on the secondary interfaces.
Thanks!
