Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
I am trying to establlish AP SSO HA between two WLC which are located between geographically different DC (within the same city), and the DC are connected bya 2 x 10Gb/s port-channel. So latency is not an issue. When I enable SSO on Standby W...
Hi There, I need some help with WCCP, however with Riverbeds instead of WAAS.The topology of the set up is as follows:WAN - R1 - LAN - L3 Switch - RiverbedThe clients reside on the WAN side and the servers reside on the LAN side. My business wishes t...
Hello,I have a tproblem where by the throughput between two inside interfaces does not go above 100KBps when copying files between the interfaces.The interfaces in question are inside1 (data vlan) and inside2 (wireless). Throughput from the inside in...
I have confirmed that the mangement/redundancy management interfaces are Layer 2 adjacent. The VLANs are spanned between the DCs, with the SVIs only configured in the Primary DC. The second WLC, when configured with a management IP prior to enabling ...
Thanks for your reply Ric. Yes I am using bonded/LAG interfaces as this is setup of the Primary/Active WLC, the configuration of which I am hoping not to alter if possible. The WLCs are 5508s so they have dedicated RP interfaces.
The guide that you h...
