Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,is there any way to configure the VSAN for an FCoE or Unified Uplink within the Cisco UCS. Starting with version 2.2 there is no field to select neither under Equipment > FI a/B nor under SAN > SAN Cloud. Cheers
Hello, make the Infra update first and then you can upload the firmware for the blades and go on with that. Did work for me for updating from 4.1 to 4.2.1f. Cheers
Hi Rohan,is this issue still ongoing for you?From the show npv status I see, that your external interface is up in VSAN 510. So your vfc 778 which is surely bind to a port-channel or ethernet port is up and running.The lower part, server interfaces, ...
Hi,finally resolved. We were facing the bug CSCuj6205 https://tools.cisco.com/bugsearch/bug/CSCuj62005.For fabric isolation I configured a non-default FCMAP on each side, but unfortunately the UCS does only work with the default FCMAP.
Hello,I can confirm this. Beginning with version 2.2 it is no longer possible to change the vsan ID.For normal FCoE-uplinks it would make sense to set the desired vsan, but it is not possible. For san uplink trunks it would make sense to set the desi...
