Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Equipment: UCS with 2 x 6248UP fabric interconnects, running version 4.2(1f).Problem: On FI A, SAN port channel 101 (fc1/29-32) connects to SAN port channel 102 (fc1/37-40) on a N5K-C5596UP switch. I'm attempting to move those four connections to SAN...
DIMMs A0 & A1 failed on my B200-M3 blade. I replaced the DIMMs with new ones. However, the 'Faults' tab in UCS Mgr still shows them as inoperable and the 'Effective memory' value on the 'General' tab is still lower than it should be.I see this in the...
I'm prepping for a UCSM upgrade from 3.2(3g) to 4.2(1f) but I'm having trouble uploading the firmware packages to the system. FYI, the domain uses 6200 series Fabric Interconnects.I downloaded the relevant 'A', 'B' and 'C' packages from Software Cent...
I'm about to have a bunch of these RAM sticks leftover from an M4 upgrade:32GB DDR4-2133-MHz LRDIMM/PC4-17000/quad rank/x4/1.2vCan I use these in an M3 blade that has E5-2600 v2 series CPUs?The M3 spec sheet says it supports quad rank 32GB LRDIMMs of...
I created a new NFS Hyperflex volume for Commvault backups, then created a (thin-provisioned) datastore on it and mounted that to the (Windows) Commvault VM. After a few days of backups, the datastore is 97% full. However, in Windows it's only about ...
I see this in the MDS log, but only one time, for one port:%PORT-5-IF_DOWN_LINK_FAILURE: %$VSAN 100%$ Interface fc1/1 is down (Link failure loss of signal)I see a lot of these:%PORT-5-IF_DOWN_OLS_RCVD: %$VSAN 100%$ Interface fc1/1 is down (OLS receiv...
That second link suggested resetting the CIMC and re-acknowledging the server. I tried that and it fixed it - the slots are now recognized and the RAM is back to its normal level.Thank you so much!!
Thank you! You're exactly right. After selecting a version number, if I then click the "Custom ISOs" tab immediately, and not the "View Group" link next to the product, I get a long list of ISOs, which I can filter with the search bar and then, boom,...
