Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to enable type 6 security on an ISR 2951 running IOS 15.7(3)M8. I type "key config-key password-encrypt [password]" and "password encryption aes" and my key chain keeps using type 7 and my logins keep using type 5. How do I change both of...
I am having issues with DNS resolutions from a switch connected to a gateway router. What's interesting is that I can ping from the switch just fine which shows me that there is connectivity to the internet however DNS resolutions don't work. I thoug...
Good MorningI am trying to integrate Cisco ACS 5.4.0.46 with AD and I have successfully linked the ACS to AD and I have successfully used AD as an authentication for network devices however my problem now is that anyone with an AD account can log int...
I've already read that documentation and implemented those steps. That doesn'thelp me because both login and keychains are still type 5 and type 7respectively.v/rBVIC
The full running config is CUI (Controlled Unclassified Information) and I cannot post it on a public forum. I am trying to work within the limits of what I can give you.
Yes the entire 192.168.42.0/23 is being NATed on the router to the singe IP address. Router#show run | se natip nat insideip nat outsideip nat pool ovrld xxx.xxx.39.118 xxx.xxx.39.118 prefix-length 30ip nat inside source list 7 pool ovrld overloadRou...
