Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have been granted access to Cisco resources as Customer Administrator for SNTC via e-mail. When I attempt to open the Smart Net Total Care Portal I get a message that states "You are not entitled to access this content." This happens through out th...
Recently upgraded to Sup720s w/ 3000w power supplies,high speed fan trays and new line cards in a 6509 chassis. I'm receiving the following log messages:--- Version 1 low-output fan-tray is in effect.--- Module 2 cannot be adequatley cooled--- Module...
I'm trying to export a "Campus User Tracking" report to a CSV file, after getting the "Exporting Report" window and clicking "OK"I get a beep and the window disappears. Can't find an exported CSV file anywhere. Is there a export report configuration ...
The Ciscoworks server restated due to a power failure (UPS ran out as well), now the ANISERVER won'tstart even after a clean shutdown. Does anyone know the procedure to correct this?
George, Thanks for checking on your end. When I checked the status of the fan this morning it had changed from "absent" to "OK". There are no entries in the log regarding the fan tray. The switch was not rebooted. So, it's a mystery!
I have reseated the fan tray, no difference. I notice on the sh idprom backplane that the hardware revision is 2. My other 6905 that was upgraded as well is hardware revision 3, this chassis does not have the problem.
I started with an empty chassis powered down. I populated it with the new modules, which included the high speed fan tray. At no time was the low speed fan tray in the chassis with the new modules. The high speed fan tray has a green status light and...
